Click image to view full size image
Body/Bonnet: Ductile iron GGG50/grey iron GG25
Disc: Ductile iron with EPDM /NBR
1. Socket Ends Non-rising Resilient Seated Gate Valve, Ductile/Cast Iron body and bonnet for high strength and impact resistance.
Valve body and bonnet fusion bonded epoxy coating for long life corrosion protection.
Straight through full bore to avoid debris traps, small flow resistance.
2. Ductile Iron wedge inside and outside fully rubberized with vulcanized EPDM or NBR, suitable for potable water.
3. Rubber bonnet gasket for longevity and protection of bonner bolts,
Isolated fasteners for corrosion protection.
4. Stainless steel stem with rolling thread for high strength and corrosion resistance.
5. Back sealing facility to allow for replacement of seals under full poeration pressure.
6. Lower thrust washer to reduce friction.
7. Ductile Iron gland thick wall casting.
8. Dust guard to prevent impurities.
9. Brass bushing for alignment, low torque operation.
10. Stem nut assembled downward.
11. Valve is supplied with hand wheel or bare shaft with square cap; Small operation torque, easy opening and closing
Socket Ends Gate Valve for PVC
